Play and charge kit
2 different coloured 0603 LEDs
Soldering iron
<2.0 flat head screwdriver
First of remove the cover use your flat head or equivalent (I used a blunt pair of scissors) be careful not to damage the plastic work you way around the edges.
Once opened you need to remove those two screws.
Now remove the plastic guard to show the led.
Remove the led by bridging both sides and the apply heat to both sides to float the led off.
Put ur new LEDs on the polarity is on the board. The top is the charging( origanaly red, bottom was green, charged) H3&J1 are +
Give it a quick test and if you did it correctly it shuld work.
Final product.
By Jmd Almighty.
