Adding and Editing Deathzones After Building with H2C

[iBotPeaches]

Zone 117

http://www.ibotmodz.net/forum/uploads/remoteimages1/2678-621.gif author.

 

 

For some reason H2C messes up Death Zones.

 

Here is how you can fix it:

[*]Open your map in Entity.[/*:m:kh1jk6i1]

[*]Open the SP map you took the BSP from.[/*:m:kh1jk6i1]

[*]Go to your singleplayer maps SCNR tag.[/*:m:kh1jk6i1]

[*]Right click and click chunk cloner.[/*:m:kh1jk6i1]

[*]Select the Death Zone reflexive.[/*:m:kh1jk6i1]

[*]Click copy to clipboard.[/*:m:kh1jk6i1]

[*]Go to your multiplayer map's SCNR chunk cloner.[/*:m:kh1jk6i1]

[*]Select the deathzone reflexive then click overwrite, then add meta to map.

[*]Ifthere isn't a deathzone reflexive, then select the second item to thevery top of the list, then click "add to selected..." then add meta tomap.[/*:m:kh1jk6i1]

 

 

A lot of times for me, when I try andmove the death zone position in Entity's BSP viewer after rebuildingwith H2C, it doesn't save, it always reverts back to it's originalPosition.

 

So here is how you can edit them:

[*]Open your map in Entity.[/*:m:kh1jk6i1]

[*]Go to the sbsp tag, click the blue plus button, click view bsp.[/*:m:kh1jk6i1]

[*]To select a deathzone, you will have to check the deathzone box, click select all spawns.[/*:m:kh1jk6i1]

[*]Move the deathzone to where you want it. [/*:m:kh1jk6i1]

[*]Click the deathzone to deselect it, then click it again to reselect it.[/*:m:kh1jk6i1]

[*]At the bottom you will see the new coords for it (X, Y, and Z) copy those coords down.[/*:m:kh1jk6i1]

[*]You can try saving, but when you exit it will most likely revert back, exit the bsp viewer.[/*:m:kh1jk6i1]

[*]Go to the scrn tag, click the blue plus button and click meta editor.[/*:m:kh1jk6i1]

[*]Go down to the Deathzone chunks.[/*:m:kh1jk6i1]

[*]Change the X, Y, and Z coord values to the ones you copied down, and save.[/*:m:kh1jk6i1]

[*]You just successfully edited your deathzone position. [/*:m:kh1jk6i1]