NWP CHIP v2 and CMD RF controller released

[iBotModz_Bot]

From eurasia.nu:

GodzIvan strikes again with an update of the Xbox 360 NAND flash write protection chip now called NWP CHIP v2 [Nand Write Protect Chip V2]. This version uses the Xbox 360 native LED ring (instead of a bi-color LED) to show status, so all you need to do is to flash a PIC12F629 microcontroller and install by soldering wires. After checking the diagram I think the solder points looks easier as well.

LED RING RED -> UNProtected

LED RING GREEN -> Protected

LED RING ORANGE -> SETTING

LED RING BLINK GREEN -> STATE SELECT ENABLE

LED RING BLINK RED -> STATE SELECT DISABLE

LED RING BLINK ORANGE -> SAVING

 

1) TURN OFF THE XBOX

2) STATUS = Press the Sync Botton for 3 secs (GREEN = Protected; RED = UNProtected)

3) SETTING MODE = Press the Sync Botton for 6 secs (till ORANGE = Setting)

4) SET PROTECTION = Press the Sync Botton for changing the setting (BLINKING GREEN = Protected; BLINKING RED = UNProtected)

5) SAVE = Press the Sync Botton for 6 secs (till BLINKING ORANGE = Saving)

http://pictures.xbox-scene.com/xbox360/nwp-chip/nwp-chip-200.jpg

 

GodzIvan also released hex dump and diagrams for CMD RF controller v0.1 which makes it possible to use the Xbox360 RF module (with game controllers) by connecting it to a PC. Thanks for sharing!

 

Official Site/Downloads: eurasia.nu

http://feedads.g.doubleclick.net/~a/_PhzOm06p71IJAlYELUdeRTgCXQ/0/di
http://feedads.g.doubleclick.net/~a/_PhzOm06p71IJAlYELUdeRTgCXQ/1/di

 

View the full article