4 replies to this topic

[ToKcItY]

I am currently using a Homemade version of action replay. It is a Microsoft Brand controller and memory card. I cut part of the breakaway cable and stripped both ends that were cut. I then cut a USB cord (male) in half with about 6 in. and stripped the end of that as well. I twisted the wires together and then crimped then with 22-26 gauge crimps. I installed XBCD and the controller was successfully hooked up to the computer. I unplugged it and put in the memory card, then plugged it back in. I used USB view to find the IDs and put then into the two xbreader files. I then installed the MaxDrive XBox driver to the USB that appeared when I plugged the controller in with the memory card. The drivers installed successfully. Then I unplugged the controller, started AR 1.40, plugged it back in and the AR logo at the top started blinking. These are just some pictures if the provide any help. If you can give and feedback, I thank you in advance.

Attached Files

•  Action replay for xbox.bmp   1.06MB   161 downloads
•  Device Manager.bmp   849.32KB   147 downloads

[iBotPeaches]

Okay, very important here.

When you disconnect and reconnect memory card, does the logo turn orange and blink? Or turn grey and blink? or turn green and blink? Or other?

They all have their own ways of saying, "error"

[ToKcItY]

Blinks Green

[iBotPeaches]

Still been helping you in chat. How is your USB2.0 coming.?

[mangriff32]

How do you make a homemade AR?